Custom Cord Stopper in Polyethylene (PE) with Injection Moulding for Outerwear and Jacket Programmes

Custom Cord Stopper — Polyethylene (PE) with Injection Moulding

We supply cord stopper to garment factories and brands, built in Polyethylene (PE) with injection moulding for denim and workwear programmes. On a trim like this the specification that decides the outcome is hole tolerance, so the cord threads without forcing, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.

The failures here are predictable: minimum order quantities far above what a growing brand can absorb, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Gold Plating — available on Polyethylene (PE), quoted per position and per colour.
• Powder Coating — available on Polyethylene (PE), quoted per position and per colour.
• Overlocked Edge — available on Polyethylene (PE), quoted per position and per colour.
• Gunmetal Plating — available on Polyethylene (PE), quoted per position and per colour.
• Chrome Plating — available on Polyethylene (PE), quoted per position and per colour.
• Ultrasonic Welding — available on Polyethylene (PE), quoted per position and per colour.
• Hard Enamel Fill — available on Polyethylene (PE), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed bore
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with injection moulding applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for OEKO-TEX Standard 100 for dyes and trims are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hole tolerance.

FAQ

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

Which compliance documents do you provide?

We prepare OEKO-TEX Standard 100 for dyes and trims and the supporting test reports for the destination market.

How long does sampling take?

A first sample takes 7 working days, and each revision about 5 days.

What is the minimum order?

Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.

Start your cord stopper programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.