Custom Rib Cuff — Denim with Sewn Edge
We supply rib cuff to garment factories and brands, built in Denim with sewn edge for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is recovery after stretch, because a cuff that bags stays bagged, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: a supplier who disappears once the deposit is paid, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Rib Cuff |
|---|---|
| Width | 6 cm |
| Construction | flat knit rib |
| Base material | Denim |
| Finish / process | Sewn Edge |
| Colour options | 6 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 3000 pieces per style per finish |
| Sampling | 12 working days, 5 days per revision |
| Bulk lead time | 25-40 days after approval |
| Compliance | SNI or SIRIM documentation per destination; REACH nickel-release test for metal findings |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Braided Weave — available on Denim, quoted per position and per colour.
- Heat-Cut Edge — available on Denim, quoted per position and per colour.
- Piece Dyeing — available on Denim, quoted per position and per colour.
- Injection Moulding — available on Denim, quoted per position and per colour.
- Stamping — available on Denim, quoted per position and per colour.
- Pantone Colour Matching — available on Denim, quoted per position and per colour.
- Tassel Finish — available on Denim, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed width
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with sewn edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same recovery after stretch.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How long does sampling take?
A first sample takes 12 working days, and each revision about 5 days.
Start your rib cuff programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
