Custom Tag Pin in Stainless Steel with Die-Casting for Denim and Workwear Programmes

Custom Tag Pin — Stainless Steel with Die-Casting

We supply tag pin to garment factories and brands, built in Stainless Steel with die-casting for denim and workwear programmes. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.

The failures here are predictable: packing that arrives mixed and unusable on the line, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Offset Printing — available on Stainless Steel, quoted per position and per colour.
• Overlocked Edge — available on Stainless Steel, quoted per position and per colour.
• Heat Transfer Printing — available on Stainless Steel, quoted per position and per colour.
• Hot Foil Stamping — available on Stainless Steel, quoted per position and per colour.
• Anti-Rust Treatment — available on Stainless Steel, quoted per position and per colour.
• Rubber Coating — available on Stainless Steel, quoted per position and per colour.
• UV Printing — available on Stainless Steel, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed length
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with die-casting applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.

FAQ

Can you do small runs across many designs?

Yes — many studio and boutique programmes run small quantities across a wide design set.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

What is the minimum order?

Programmes start at 3000 pieces per style per finish. Mixed sizes are fine within one style.

Start your tag pin programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.