Custom Tag Pin — Nylon (PA) with Digital Printing
We supply tag pin to garment factories and brands, built in Nylon (PA) with digital printing for denim and workwear programmes. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or packing that arrives mixed and unusable on the line. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Tag Pin |
|---|---|
| Length | 50 mm |
| Type | barbless pin |
| Base material | Nylon (PA) |
| Finish / process | Digital Printing |
| Colour options | 8 Pantone-matched shades |
| Packing | carded |
| MOQ | 2000 pieces per style per finish |
| Sampling | 10 working days, 4 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | SNI or SIRIM documentation per destination; salt spray test for metal finishes |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Sewn Edge — available on Nylon (PA), quoted per position and per colour.
- Hot Foil Stamping — available on Nylon (PA), quoted per position and per colour.
- Injection Moulding — available on Nylon (PA), quoted per position and per colour.
- Offset Printing — available on Nylon (PA), quoted per position and per colour.
- Soft Enamel Fill — available on Nylon (PA), quoted per position and per colour.
- Hard Enamel Fill — available on Nylon (PA), quoted per position and per colour.
- Debossing — available on Nylon (PA), quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with digital printing applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.
FAQ
How long does sampling take?
A first sample takes 10 working days, and each revision about 4 days.
Which compliance documents do you provide?
We prepare salt spray test for metal finishes and the supporting test reports for the destination market.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Start your tag pin programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
