Custom Tag Pin — Brass with Injection Moulding
We supply tag pin to garment factories and brands, built in Brass with injection moulding for uniform and corporate programmes. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: shade variation within one carton, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Tag Pin |
|---|---|
| Length | 35 mm |
| Type | barbless pin |
| Base material | Brass |
| Finish / process | Injection Moulding |
| Colour options | 24 Pantone-matched shades |
| Packing | reel packed |
| MOQ | 500 pieces per style per finish |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; EN 71 part 3 for decorative components |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Die-Casting — available on Brass, quoted per position and per colour.
- Rubber Coating — available on Brass, quoted per position and per colour.
- Debossing — available on Brass, quoted per position and per colour.
- Soft Enamel Fill — available on Brass, quoted per position and per colour.
- Anti-Rust Treatment — available on Brass, quoted per position and per colour.
- UV Printing — available on Brass, quoted per position and per colour.
- Sewn Edge — available on Brass, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.
FAQ
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
What is the minimum order?
Programmes start at 500 pieces per style per finish. Mixed sizes are fine within one style.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Start your tag pin programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
