Custom Tag Pin in Polypropylene (PP) with Hard Enamel Fill for Uniform and Corporate Programmes

Custom Tag Pin — Polypropylene (PP) with Hard Enamel Fill

We supply tag pin to garment factories and brands, built in Polypropylene (PP) with hard enamel fill for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is needle compatibility with the tagging gun on your line, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.

The failures here are predictable: unclear responsibility when a defect shows up after washing, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Die-Casting — available on Polypropylene (PP), quoted per position and per colour.
• Sewn Edge — available on Polypropylene (PP), quoted per position and per colour.
• Soft Enamel Fill — available on Polypropylene (PP), quoted per position and per colour.
• Digital Printing — available on Polypropylene (PP), quoted per position and per colour.
• Stamping — available on Polypropylene (PP), quoted per position and per colour.
• Hot Foil Stamping — available on Polypropylene (PP), quoted per position and per colour.
• Epoxy Dome — available on Polypropylene (PP), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed length
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with hard enamel fill applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same needle compatibility with the tagging gun on your line.

FAQ

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

Which compliance documents do you provide?

We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.

What is the minimum order?

Programmes start at 3000 pieces per style per finish. Mixed sizes are fine within one style.

Start your tag pin programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.