Custom Tag Pin in Nickel-Free Alloy with Hot Foil Stamping for Bridal and Eveningwear Studios

Custom Tag Pin — Nickel-Free Alloy with Hot Foil Stamping

We supply tag pin to garment factories and brands, built in Nickel-Free Alloy with hot foil stamping for uniform and corporate programmes. On a trim like this the specification that decides the outcome is material that does not damage fine fabric, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.

The failures here are predictable: unclear responsibility when a defect shows up after washing, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Paint Spray — available on Nickel-Free Alloy, quoted per position and per colour.
• Powder Coating — available on Nickel-Free Alloy, quoted per position and per colour.
• Injection Moulding — available on Nickel-Free Alloy, quoted per position and per colour.
• Soft Enamel Fill — available on Nickel-Free Alloy, quoted per position and per colour.
• Rubber Coating — available on Nickel-Free Alloy, quoted per position and per colour.
• UV Printing — available on Nickel-Free Alloy, quoted per position and per colour.
• Anti-Rust Treatment — available on Nickel-Free Alloy, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed length
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with hot foil stamping applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same material that does not damage fine fabric.

FAQ

Which compliance documents do you provide?

We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

What is the minimum order?

Programmes start at 5000 pieces per style per finish. Mixed sizes are fine within one style.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

Start your tag pin programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.