Custom Tag Pin in Polyethylene (PE) with Die-Casting for Childrenswear and Schoolwear

Custom Tag Pin — Polyethylene (PE) with Die-Casting

We supply tag pin to garment factories and brands, built in Polyethylene (PE) with die-casting for e-commerce and small-batch brands. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.

The failures here are predictable: packing that arrives mixed and unusable on the line, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare UKCA and REACH documentation so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Sewn Edge — available on Polyethylene (PE), quoted per position and per colour.
• UV Printing — available on Polyethylene (PE), quoted per position and per colour.
• Stamping — available on Polyethylene (PE), quoted per position and per colour.
• Rubber Coating — available on Polyethylene (PE), quoted per position and per colour.
• Dye-Sublimation Printing — available on Polyethylene (PE), quoted per position and per colour.
• Ultrasonic Welding — available on Polyethylene (PE), quoted per position and per colour.
• Epoxy Dome — available on Polyethylene (PE), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed length
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with die-casting applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.

FAQ

Can you do small runs across many designs?

Yes — many studio and boutique programmes run small quantities across a wide design set.

Which compliance documents do you provide?

We prepare REACH nickel-release test for metal findings and the supporting test reports for the destination market.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

How long does sampling take?

A first sample takes 10 working days, and each revision about 4 days.

Start your tag pin programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.