Custom Tag Pin — Pewter with Injection Moulding
We supply tag pin to garment factories and brands, built in Pewter with injection moulding for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: inconsistent sizing between production runs, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Tag Pin |
|---|---|
| Length | 75 mm |
| Type | fine fabric pin |
| Base material | Pewter |
| Finish / process | Injection Moulding |
| Colour options | 8 Pantone-matched shades |
| Packing | carded |
| MOQ | 1000 pieces per style per finish |
| Sampling | 7 working days, 5 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | SNI or SIRIM documentation per destination; colour fastness to washing, rubbing and light |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Stamping — available on Pewter, quoted per position and per colour.
- Hard Enamel Fill — available on Pewter, quoted per position and per colour.
- Embossing — available on Pewter, quoted per position and per colour.
- Anti-Rust Treatment — available on Pewter, quoted per position and per colour.
- Debossing — available on Pewter, quoted per position and per colour.
- Injection Moulding — available on Pewter, quoted per position and per colour.
- Soft Enamel Fill — available on Pewter, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.
FAQ
Which compliance documents do you provide?
We prepare colour fastness to washing, rubbing and light and the supporting test reports for the destination market.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
How long does sampling take?
A first sample takes 7 working days, and each revision about 5 days.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
Start your tag pin programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
