Custom Tag Pin — Stainless Steel with Stamping
We supply tag pin to garment factories and brands, built in Stainless Steel with stamping for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is material that does not damage fine fabric, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: shade variation within one carton, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Tag Pin |
|---|---|
| Length | 25 mm |
| Type | standard tag pin |
| Base material | Stainless Steel |
| Finish / process | Stamping |
| Colour options | 12 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 1000 pieces per style per finish |
| Sampling | 12 working days, 5 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | SNI or SIRIM documentation per destination; azo dye-free declaration |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Paint Spray — available on Stainless Steel, quoted per position and per colour.
- Overlocked Edge — available on Stainless Steel, quoted per position and per colour.
- Hot Foil Stamping — available on Stainless Steel, quoted per position and per colour.
- Offset Printing — available on Stainless Steel, quoted per position and per colour.
- Soft Enamel Fill — available on Stainless Steel, quoted per position and per colour.
- Heat Transfer Printing — available on Stainless Steel, quoted per position and per colour.
- Ultrasonic Welding — available on Stainless Steel, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with stamping applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for azo dye-free declaration are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same material that does not damage fine fabric.
FAQ
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
How long does sampling take?
A first sample takes 12 working days, and each revision about 5 days.
Start your tag pin programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
