Custom Tag Pin — Pewter with Anti-Rust Treatment
We supply tag pin to garment factories and brands, built in Pewter with anti-rust treatment for denim and workwear programmes. On a trim like this the specification that decides the outcome is material that does not damage fine fabric, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare UKCA and REACH documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Tag Pin |
|---|---|
| Length | 50 mm |
| Type | loop lock pin |
| Base material | Pewter |
| Finish / process | Anti-Rust Treatment |
| Colour options | 16 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 2000 pieces per style per finish |
| Sampling | 12 working days, 5 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | UKCA and REACH documentation; CPSIA lead and phthalate testing |
| Ship to | Felixstowe (the United Kingdom) |
What buyers can customise
- Soft Enamel Fill — available on Pewter, quoted per position and per colour.
- Overlocked Edge — available on Pewter, quoted per position and per colour.
- Heat Transfer Printing — available on Pewter, quoted per position and per colour.
- UV Printing — available on Pewter, quoted per position and per colour.
- Debossing — available on Pewter, quoted per position and per colour.
- Anti-Rust Treatment — available on Pewter, quoted per position and per colour.
- Screen Printing — available on Pewter, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with anti-rust treatment applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same material that does not damage fine fabric.
FAQ
How long does sampling take?
A first sample takes 12 working days, and each revision about 5 days.
Which compliance documents do you provide?
We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Start your tag pin programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
