Custom Tag Pin in Polypropylene (PP) with Hard Enamel Fill for Denim and Workwear Programmes

Custom Tag Pin — Polypropylene (PP) with Hard Enamel Fill

We supply tag pin to garment factories and brands, built in Polypropylene (PP) with hard enamel fill for denim and workwear programmes. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.

The failures here are predictable: inconsistent sizing between production runs, or packing that arrives mixed and unusable on the line. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Ultrasonic Welding — available on Polypropylene (PP), quoted per position and per colour.
• Overlocked Edge — available on Polypropylene (PP), quoted per position and per colour.
• Paint Spray — available on Polypropylene (PP), quoted per position and per colour.
• Heat Transfer Printing — available on Polypropylene (PP), quoted per position and per colour.
• Injection Moulding — available on Polypropylene (PP), quoted per position and per colour.
• Offset Printing — available on Polypropylene (PP), quoted per position and per colour.
• Hot Foil Stamping — available on Polypropylene (PP), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed length
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with hard enamel fill applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for azo dye-free declaration are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.

FAQ

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

What is the minimum order?

Programmes start at 500 pieces per style per finish. Mixed sizes are fine within one style.

Which compliance documents do you provide?

We prepare azo dye-free declaration and the supporting test reports for the destination market.

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

Start your tag pin programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.