Custom Tag Pin in Polyethylene (PE) with Screen Printing for Outerwear and Jacket Programmes

Custom Tag Pin — Polyethylene (PE) with Screen Printing

We supply tag pin to garment factories and brands, built in Polyethylene (PE) with screen printing for denim and workwear programmes. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.

The failures here are predictable: a supplier who disappears once the deposit is paid, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Rubber Coating — available on Polyethylene (PE), quoted per position and per colour.
• Debossing — available on Polyethylene (PE), quoted per position and per colour.
• Dye-Sublimation Printing — available on Polyethylene (PE), quoted per position and per colour.
• Heat Transfer Printing — available on Polyethylene (PE), quoted per position and per colour.
• Screen Printing — available on Polyethylene (PE), quoted per position and per colour.
• Offset Printing — available on Polyethylene (PE), quoted per position and per colour.
• Overlocked Edge — available on Polyethylene (PE), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed length
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with screen printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.

FAQ

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

How long does sampling take?

A first sample takes 7 working days, and each revision about 4 days.

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

Which compliance documents do you provide?

We prepare REACH nickel-release test for metal findings and the supporting test reports for the destination market.

Start your tag pin programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.