Custom Tag Pin — ABS Plastic with Die-Casting
We supply tag pin to garment factories and brands, built in ABS Plastic with die-casting for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is head strength, because a snapped head leaves the pin in the garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: a supplier who disappears once the deposit is paid, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Tag Pin |
|---|---|
| Length | 75 mm |
| Type | standard tag pin |
| Base material | ABS Plastic |
| Finish / process | Die-Casting |
| Colour options | 12 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 5000 pieces per style per finish |
| Sampling | 10 working days, 5 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; CPSIA lead and phthalate testing |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Hard Enamel Fill — available on ABS Plastic, quoted per position and per colour.
- Stamping — available on ABS Plastic, quoted per position and per colour.
- Sewn Edge — available on ABS Plastic, quoted per position and per colour.
- Overlocked Edge — available on ABS Plastic, quoted per position and per colour.
- Digital Printing — available on ABS Plastic, quoted per position and per colour.
- Anti-Rust Treatment — available on ABS Plastic, quoted per position and per colour.
- Heat Transfer Printing — available on ABS Plastic, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with die-casting applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same head strength.
FAQ
What is the minimum order?
Programmes start at 5000 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 10 working days, and each revision about 5 days.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Start your tag pin programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
