Custom Thread Trimmer — Iron with Brushed Finish
We supply thread trimmer to garment factories and brands, built in Iron with brushed finish for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is tip safety, since trimming happens close to the finished garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: minimum order quantities far above what a growing brand can absorb, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Thread Trimmer |
|---|---|
| Blade length | 45 mm |
| Type | thread clipper |
| Base material | Iron |
| Finish / process | Brushed Finish |
| Colour options | 6 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 3000 pieces per style per finish |
| Sampling | 10 working days, 3 days per revision |
| Bulk lead time | 15-50 days after approval |
| Compliance | GSO conformity with Arabic labelling; REACH nickel-release test for metal findings |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Hard Enamel Fill — available on Iron, quoted per position and per colour.
- Rubber Coating — available on Iron, quoted per position and per colour.
- Ultrasonic Welding — available on Iron, quoted per position and per colour.
- Stamping — available on Iron, quoted per position and per colour.
- Injection Moulding — available on Iron, quoted per position and per colour.
- Paint Spray — available on Iron, quoted per position and per colour.
- Soft Enamel Fill — available on Iron, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed blade length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with brushed finish applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same tip safety.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Which compliance documents do you provide?
We prepare REACH nickel-release test for metal findings and the supporting test reports for the destination market.
What is the minimum order?
Programmes start at 3000 pieces per style per finish. Mixed sizes are fine within one style.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Start your thread trimmer programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
