Custom Mannequin in Polypropylene (PP) with Offset Printing for Childrenswear and Schoolwear

Custom Mannequin — Polypropylene (PP) with Offset Printing

We supply mannequin to garment factories and brands, built in Polypropylene (PP) with offset printing for denim and workwear programmes. On a trim like this the specification that decides the outcome is measurement accuracy against the size chart you sell, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.

The failures here are predictable: a finish that tarnishes or rubs off after washing, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Woven Jacquard — available on Polypropylene (PP), quoted per position and per colour.
• Hot Foil Stamping — available on Polypropylene (PP), quoted per position and per colour.
• Dye-Sublimation Printing — available on Polypropylene (PP), quoted per position and per colour.
• Embroidery — available on Polypropylene (PP), quoted per position and per colour.
• Hard Enamel Fill — available on Polypropylene (PP), quoted per position and per colour.
• Epoxy Dome — available on Polypropylene (PP), quoted per position and per colour.
• Crochet — available on Polypropylene (PP), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed height
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with offset printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for GRS recycled content claim are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same measurement accuracy against the size chart you sell.

FAQ

What is the minimum order?

Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.

Which compliance documents do you provide?

We prepare GRS recycled content claim and the supporting test reports for the destination market.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

Start your mannequin programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.