Custom Thread Trimmer — Stainless Steel with Overlocked Edge
We supply thread trimmer to garment factories and brands, built in Stainless Steel with overlocked edge for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is tip safety, since trimming happens close to the finished garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: packing that arrives mixed and unusable on the line, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Thread Trimmer |
|---|---|
| Blade length | 60 mm |
| Type | serrated blade trimmer |
| Base material | Stainless Steel |
| Finish / process | Overlocked Edge |
| Colour options | 8 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 5000 pieces per style per finish |
| Sampling | 7 working days, 5 days per revision |
| Bulk lead time | 25-50 days after approval |
| Compliance | SNI or SIRIM documentation per destination; EN 71 part 3 for decorative components |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Epoxy Dome — available on Stainless Steel, quoted per position and per colour.
- Stamping — available on Stainless Steel, quoted per position and per colour.
- Mirror Polish — available on Stainless Steel, quoted per position and per colour.
- Black Oxide — available on Stainless Steel, quoted per position and per colour.
- Rubber Coating — available on Stainless Steel, quoted per position and per colour.
- Nickel Plating — available on Stainless Steel, quoted per position and per colour.
- Chrome Plating — available on Stainless Steel, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed blade length
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with overlocked edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same tip safety.
FAQ
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How long does sampling take?
A first sample takes 7 working days, and each revision about 5 days.
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
What is the minimum order?
Programmes start at 5000 pieces per style per finish. Mixed sizes are fine within one style.
Start your thread trimmer programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
